Turn In Concepts Shift Linkage Bushings Subaru STI 2004-2005

Part #: TIC - 1001 - 01 - 0001. Have you ever missed a 2 - 3 shift because of stick slop? These shift linkage bushings from Turn In Concepts are your perfect solution! Specifically designed for the 2004 and 2005 USDM Subaru Impreza WRX STi, they eliminate shifter free play. This gives your shifter a better feel and makes gear selection 'click' smoothly into place. To understand their value, let's look at stock linkage bushings. There's a joint between the shifter linkage arm and the control arm leading to the transmission, which causes lateral stick play. The stock joint has a u - joint assembly with welded tubes and bushings, sleeve bearings, and bolts. In the stock setup, two gaps create play: between the bolt and the sleeve bearing, and between the sleeve bearing and the bushings. Our bushings target the second gap. Over time, stock soft rubber bushings compress, leading to more stick slop. Our polyurethane bushings have tighter tolerances than stock ones, reducing slop significantly. They're also more resistant to compression while keeping NVH at an acceptable level.

Using these shift linkage bushings is straightforward. First, make sure your car is parked on a flat surface and the engine is off. Locate the shifter linkage arm and the control arm going into the transmission. Remove the old bushings carefully. Then, install the new polyurethane bushings in their place. Ensure they fit snugly. When it comes to maintenance, there's not much you need to do. Just check the bushings periodically for any signs of wear and tear. If you notice excessive slop returning or any damage, it might be time to replace them. And remember, these bushings are designed to work well with your 2004 - 2005 Subaru STI, so don't try to use them in other vehicles without consulting a professional.