Part #: STF-ULOGB-WRX2015. If you're looking to make your WRX stand out from the stock version, these overlays are an affordable and stylish solution. They're incredibly easy to install. These overlays are designed to go over the painted fender vent area below the WRX or STI logo, making the fender vent more prominent. Sold as a set, and only one set is needed per vehicle. Fender emblems are not included. For the best installation results, clean the painted fender vent surface. Apply water or a soapy water mix to both the area and the vinyl. This lets you adjust the product's position without it bunching up due to the adhesive. Once positioned, press the vinyl down with your finger. Avoid using a squeegee as it can damage the vinyl. You can press out the water with your fingers. Using heat from a heat gun or hair dryer can help the adhesive bond and stretch the product to fill gaps. Start with low heat and see how the vinyl reacts. Remember, if the heat is too much for your fingers, it's probably too much for the vinyl.
Using these fender overlays is easy. First, clean the painted surface of the fender vent where you'll place them. Then, apply water or a soapy water mix to both the surface and the vinyl. This makes it easy to move the overlay around and get it in the right position without it sticking too soon. Once it's where you want it, press the vinyl down with your finger to remove the water. Don't use a squeegee because it can scratch the vinyl. If you need to stretch the overlay to fill gaps, you can use a heat gun or a hair dryer. But start with low heat and see how the vinyl reacts. As a rule, if the heat is too hot for your fingers, it's too hot for the vinyl. As for maintenance, just clean them with a mild soap and water solution. Avoid using harsh chemicals that could damage the glossy finish. With proper care, these overlays will keep your WRX looking great for a long time.
