FactionFab Front Stainless Steel Brake Lines Subaru STI 2004-2007 / WRX 2006-2007

Part #: FFA1.10094.1. Upgrade your braking system with Faction Fab's F-Spec Stainless Steel Brake Lines. Say goodbye to the soft and expandable factory rubber lines. These stainless - steel brake lines offer a more direct response from the brake pedal to the caliper, boosting your confidence and improving stopping power. Construction details: It has a PTFE Teflon inner liner to carry the fluid, a stainless - steel woven middle layer for support, is abrasion and impact - resistant, and features an outer PCV clear abrasion - resistant coating to protect inner layers. Features: Each line is tested to a 4500psi burst pressure, comes with stainless - steel precision machined fittings for a perfect fit and corrosion resistance. By eliminating soft rubber lines prone to swelling and deforming, you'll get increased pedal feedback. These lines are 100% model - specific for a perfect fit and include all necessary hardware. They are designed for the front location of your vehicle.

Using these Faction Fab brake lines is straightforward. First, make sure your vehicle is parked on a flat surface and the engine is off. Refer to your vehicle's manual to locate the front brake lines. Remove the old factory rubber lines carefully, taking note of how they are attached. Then, install the new stainless - steel brake lines, using the included hardware. Make sure all fittings are tightened properly. After installation, bleed the brakes to remove any air from the system. This will ensure optimal braking performance. As for maintenance, regularly check the brake lines for any signs of damage or wear, such as cuts or leaks. If you notice any issues, replace the lines immediately. Keep the lines clean by wiping them down occasionally with a soft cloth. Also, during cold weather, pay extra attention as extreme temperatures can affect the performance of the braking system.