Part #: KIT-OEMHW-1. If you're not reusing your original short - block service plugs and covers, this is the perfect comprehensive cover and seal kit. It includes a rear main seal, three wrist pin plugs and washers, a separator cover with six bolts, a wrist pin service cover with an O - ring, and two screws. OEM part numbers are 806786040 (1), 11831AA210 (1), 800406140 (5), 800406150 (1), 11021AA020 (3), 803928010 (3), 11093AA000 (1), 806931070 (1), 801506040 (2).
Using this Subaru OEM Hardware and Seal Kit is easy. First, make sure your engine is turned off and cooled down. Carefully remove the old plugs and covers from your EJ series engine. Then, install the new parts included in the kit one by one. For example, place the rear main seal in the correct position and fit the wrist pin plugs and washers properly. When attaching the separator cover, use the six bolts provided. Don't forget to put the O - ring on the wrist pin service cover before screwing it on with the two screws. As for maintenance, check the seals and plugs regularly for any signs of wear or damage. If you notice any issues, replace the parts right away. Also, keep the kit in a dry and clean place when not in use to prevent rust or other damage.
