ISR Performance Driveshaft – LS Swap S14 Non ABS – Steel

Part #: IS - DS - LSS14 - S. This ISR driveshaft is designed for 240SX cars with an LS1 T56 steel shaft. It's a single - shaft conversion for the 240SX platform. The driveshaft features large, replaceable, and greaseable u - joints and can handle up to about 650 wheel horsepower. By removing the factory 2 - piece shaft and installing this single shaft, your car will respond more quickly as the hanger bearing won't move up and down during acceleration. It's available for most common motor/trans combinations. If your specific setup isn't listed, custom shafts can be made. Note that whether your car has ABS or you're using an ABS diff will change the driveshaft length. Check your vehicle before ordering and select the right options from the menu above. This driveshaft is for S Chassis LS swaps using the ISR LS swap mount. It's built to order with a 3 - 4 week lead time.

Using the ISR Performance driveshaft is straightforward. First, make sure to remove the factory 2 - piece shaft from your 240SX with an LS1 T56 setup. Then, install the new single - shaft driveshaft. During installation, pay close attention to the fit and alignment. Before ordering, always check if your car has ABS or if you're using an ABS diff, as this affects the driveshaft length. You can select the appropriate options from the menu. Maintenance is easy. Regularly check the u - joints and make sure they are greased. These u - joints are replaceable, so if you notice any wear, you can swap them out. Remember, this driveshaft is built to order, so expect a 3 - 4 week lead time before it arrives.