ISR Performance Driveshaft – RB Swap S14 Non ABS – Steel

Part #: IS - DS - RBS14 - S. This ISR steel driveshaft is designed for 240SX cars with RB25 5 - Speed. It's a single - shaft conversion for the 240SX platform. The shaft has larger, replaceable, and greaseable u - joints and can handle around 650WHP. By replacing the factory 2 - piece shaft with this single shaft, your car will respond better as the hanger bearing won't move up and down during acceleration. It's available for most common motor/trans combinations. If yours isn't listed, custom shafts can be made. Note that whether the car has ABS or you're using an ABS Diff affects the driveshaft length. Check your vehicle before ordering and select options from the menu above. This driveshaft is for S Chassis RB25 using the ISR RB swap mount. It's built to order with a 2 - 3 week lead time.

Using this ISR driveshaft is straightforward. First, remove the factory 2 - piece driveshaft from your 240SX with RB25 5 - Speed. Then, install this single - shaft driveshaft. During acceleration, you'll notice your car is more responsive. Before ordering, always check if your car has ABS or if you're using an ABS Diff, as this will change the driveshaft length. Make sure to select the right options from the menu. For maintenance, the u - joints are replaceable and greaseable. Regularly check and grease them to keep the driveshaft in good condition. Since it's built to order, expect a 2 - 3 week wait time for your new driveshaft.