Sticker Fab Tail Light Tint Overlays Subaru WRX / STI 2015-2021

Vinyl overlays can transform the look of your vehicle without costing a fortune. Instantly upgrade your OEM tail lights from ordinary to extraordinary. These overlays come in a pair (left/right). You can choose from various colors, including dark smoke, light smoke, red, yellow, and chameleon. Note that these are overlays, not tail lights, and they cover the reverse light and turn signal. Check the pictures for installation details and follow the instructions below. The dark smoke color shown in the pictures is quite striking, and the light smoke is about half as dark.

To install these tail light overlays, first clean the surface of the tail light. Start by placing the material in the bottom - corner near the trunk. It's best to use a wet installation with a water/soap mix. This lets you easily slide the overlay into position. Use your fingers or a soft tool to remove air bubbles. Let the vehicle sit in the sun for a while to dry. Once dry, you can power wash it or use an automatic car wash. If you're in a hurry, you can use a hair dryer or light heat to speed up the drying process. Remember, chameleon overlays have a thin protective layer that might come off with some effort or over time. Just keep an eye on it and enjoy the new look of your car.