ISR Performance Driveshaft – LS Swap S14 ABS – Steel

Part #: IS-DS-LSS14ABS-S. This is an ISR single shaft conversion for the 240SX platform with an LS1 T56 steel shaft. It has larger, replaceable, and greaseable u-joints and can handle around 650WHP. By replacing the factory 2-piece shaft with a single shaft, your car will respond better as the hanger bearing won't move up and down during acceleration. Available for most common motor/trans combos. Custom shafts are also an option if yours isn't listed. Note: The driveshaft length changes depending on whether the car has ABS or you're using an ABS Diff. Check your vehicle before ordering and select options from the menu above. This is for S Chassis LS Swap using the ISR LS swap mount. Built to order with a 3 - 4 week lead time.

Using this driveshaft is easy. First, remove the factory 2 - piece shaft from your 240SX with an LS1 T56. Then, install the single shaft. It will make your car more responsive during acceleration. When ordering, always check if your car has ABS or if you're using an ABS Diff as this affects the driveshaft length. Select the right options from the menu. As for maintenance, the u - joints are replaceable and greaseable. Regularly check and grease them to keep the driveshaft in good condition. Since it's built to order, expect a 3 - 4 week lead time.